Build a job checklist for work orders.
Make a list of steps and questions that technicians fill in on a work order.
- 7 steps
- 4 min read
Part of the path for Service managers
Before you start
Sign in as an administrator. All names in this example are fictional.
What is a job checklist?
A job checklist is a short form a technician fills in during a job, for example: What state was the filter in? Take a photo of the unit. The answers are saved on the work order, so the office can see what was checked.
You build the checklist once as a template. It then shows on the Checklists tab of every work order it applies to. You can limit it to some work order types, divisions or billing modes, or leave those empty so it shows on every work order.
A checklist can also be tied to a status. For example, you can make the technician fill it in before the work order can be set to Completed.
A job checklist belongs to a work order and lists the steps of the job. An inspection form belongs to a piece of equipment.
Open Settings
In the left side menu, under Administration, click Settings.
Open the job checklists
Click System in the list of settings. Under Work order defaults, click Manage job checklists.
Start a new template
The Job checklist templates page lists the checklists you already have. Click New template at the top right.
Name it and choose when it is used
In Template name, enter a clear name, for example Rooftop unit service checklist. In Description, say what it is for. Keep Allow manual run turned on so technicians can open it from the work order. Applies to work order types starts with Contract Maintenance and Applies to divisions starts with Service: to make the checklist show on every work order, click in Applies to work order types and press Backspace until it is empty. Keep them if the checklist is only for contract maintenance.
Add the first field
Under Fields, Field 1 is ready. In Label, type the question, for example Filter condition. In Field type, choose the kind of answer, here Single selection. In Options, type each choice and press Enter: Clean, Dirty, Replaced.
Add more fields
Click Add field for each new question. Here Field 2 is Photo of the unit with the type Single image, so the technician must add a photo. Other types are text, number, date, time, check boxes and section headers.
Save the template
Click Save template at the top right. Saving can take a few seconds: wait until the UNSAVED tag at the top goes away. Go back to the Template menu and type the name in Search templates: your checklist is in the list with its number of fields.
The result.
The checklist template is saved. It now shows on the Checklists tab of every work order it applies to, ready for a technician to run.
If you get stuck
If Save template does nothing, look for a red message: every field needs a label, and a selection field needs at least one option. If the checklist does not show on a work order, check Applies to work order types, Applies to divisions and Applies to billing mode: the work order must match them, or leave them empty. Use Trigger status to open the checklist by itself when the work order reaches a status, and Required before status can change to to block a status change until it is filled in.
What to do next
Fill in a checklist on a work order
Answer a job checklist on a work order and find the saved answers later.
6 simple steps →Inspection formsBuild an inspection form
Make a form your technicians fill in when they inspect a piece of equipment.
5 simple steps →Work ordersChange the status of a work order and complete it
Move a work order from scheduled to in progress, then mark it completed.
5 simple steps →